Partial list of this KitchenAid Top Load Washer components
(for additional details, please see All Parts & Diagrams
Front cover section contains . Top and cabinet parts include switch, lid bumper, lid hinge almond rivet, serial nameplate stop, push-in top clip, top & cabinet & rear panel (2) almond pad, lid hinge (2) sound-damper (cabinet) spacer, cabinet to top (4). Rear panel parts are hinge, console (2) clamp, hose pad, rear panel shield, suds valve, water mixing hose, pump to tub washer, water inlet hose (4) (1-1/16 x 5/8) clamp, hose hose, water inlet (2) hose, drain (5 1/2 ft.). Control panel section includes cap, end (r.h.) screw, 10-24 x 3/8 (alt.) knob, water level bracket, control (alt.) console, panel switch, water temperature timer, control 60 hz. (motor not serviced) trim, endcap (r.h.). Brake, clutch, gearcase, motor and pump components are ring, spin tube support cap, clutch spring (2) washer, spin tube thrust grommet, motor (4) gearcase (complete) (refer to page for further breakdown) shield, tub to motor clip, anti-rattle clamp, capacitor screw, gearcase to base (3) (5/16-24 x 3/4) shield, motor. Agitator, basket and tub components are dog, agitator clutch (4) seal, inner auger gasket, centerpost screw & washer (5-16-24 x 1) dispenser, rinse seal, agitator clothes mover clamp, hose clip, agitator hose, pressure switch. Miscellaneous section includes miscellaneous parts bag foot, front (2) nut, lock (2) (3/8-16) washer, inlet hose (1-1/16 x 5/8) (4) clamp, hose. Machine base components are base assembly (includes illus, 6, 7, 8, 9, 18 & 26) nut, lock (3/8-16) (2) plate, suspension (includes illus. 16) bearing, centerpost (2) spring, suspension (3) screw, bracket mounting (10-16 x 5/8) (6) foot, rear (2) 10-16 x 3/8 (2) pad, base ring, sound deadening spring, leveling mechanism. Wiring harness section contains terminal, female block, disconnect (motor) receptacle, terminal (2 way) terminal, male clip, harness clip, harness wiring harness & pressure switch hose plug terminal (power cord) block, disconnect (timer) (black) terminal, female. Gearcase is composed of rack, connecting screw, gearcase cover mounting (8) shaft, agitator (complete) gear, main drive washer, cam thrust spring, agitate washer kit, thrust cover, gearcase seal, thrust plug seal, gearcase cover. Brake and drive tube parts are seal, oil ring, retaining seal, drive tube brake and drive tube (complete) driver, brake cam sleeve, cam lubricant (use only in brake shoe assembly on roller & pin) shoe, brake tube, basket drive (includes illus. 3, 4, 5 & 9) cap, brake spring (2).