Page 0 parts are literature parts (use & care guide). Top and cabinet parts parts include toe panel (pewter) bracket, spring screw clamp, hose screw, 3 x 8 mm clamp, tube transportation brace, rear top (biscuit) hose, pressure switch toe panel (white). Door and latch parts is composed of door frame asm (pewter) screw trim, lower (pewter) cover, hinge (outer) (platinum) screw clip, trim lock, door door frame asm (blue) pin, safety trim, upper left (platinum). Control panel parts parts are button, start harness, wiring (main) panel, control (blue) knob, control (platinum) window, display bezel, knob button set, spin/temperature (blue) knob, control (pewter) light, indicator (4 lights) endcap, right (pewter). Dispenser parts components are o-ring hook, drawer spring, lever nozzle, inlet connection, lever cam, actuator clamp valve, inlet harness, wiring (inlet valve) handle, drawer (biscuit). Tub and basket parts parts are o-ring gasket, tub grid, ventilation belt spring, suspension tub, rear baffle, basket screw clamp pipe, ventilation. Pump and motor parts and optional parts (not included) parts are clamp paint, touch-up (1/2oz.) (pewter) paint, touch-up (1/2oz.) (biscuit) clamp bolt, motor retainer, drain hose pump (complete) drain extension screw paint, bulk (1 qt.) (biscuit). Pedestal parts (not included) section contains divider, drawer (set of 2) (for lab2700pmt) cabinet (not serviced) drawer front assembly (meteorite) pad (4) slide assembly foot assembly screw drawer front assembly (biscuit) literature parts (installation instructions) screw, 6-20 x 3/8.
What is the Whirlpool Duet Washer GHW9250MW2 tub capacity?
Tub Capacity as per Manufacturer Specifications (in cubic feet):
The manufacturers began using cubic feet capacity numbers only recently.
Previously, they used relative terms such as "Large" or "Extra Capacity" or laundry weight (e.g. "16 lbs per load")
which did not take into account different fabric weight and volume. Others referred to capacity in
terms of water used. Even washers available today do not have capacity written in the manual because the same manual
can be used across multiple models. Once the washer is no longer sold, the sales literature is discarded
and capacity information often lost.
Analyzing washers and their components, searching through old technical information and sales literature, and
determining their capacity is a labor intensive and time-consuming task and we are far from finished.
A small charge will help us continue our research.
Consider this: if you were to spend more than four minutes looking for tub capacity on the internet, you
would be earning LESS than minimum wage.
Calculate Washer Tub capacity
This is a geometric method to calculate tub capacity based on the cylinder volume formula.
Unfortunately, the value could be as much as 25% off from the manufacturer stated capacity.
Why? Because the tub is not exactly a cylinder. The edge where bottom connected to the wall
is not at 90 degree angle but smooth and rounded. The water line is not clearly marked and
the bottom is not always flat. Finally, an agitator also takes capacity away from the tub.
This method can be used as a crude estimate but we do not recommend using it for comparisson
when shopping for a new washer.
Determine your washer tub capacity by taking two simple measurements:
1. Use the ruler to measure the depth of the tub (indicated by the red line on the diagram)
2. Now find the distance accross the tub, the diameter (the green line on the diagram). Note that some tubs are narrow
on top. In this case make the measurements INSIDE the tub.
Tub Depth: in. Tub Diameter: in.
The Whirlpool Duet Washer GHW9250MW2 tub capacity is ... cubic feet.